Ready Steady Rules

Gas fitting by a licensed gas service worker

Any gas pipework or appliance connection in your kitchen — hobs, ranges, water heaters — has to be installed and connected by an EMA-licensed gas service worker.

Not yet independently verified — check the source link: The exact 30 mbar pressure threshold splitting EMA’s gas-fitting licensing tiers was not independently confirmed against a primary EMA source this pass — confirm before relying on it.

Any gas pipework or appliance connection in your kitchen — hobs, ranges, water heaters — has to be installed and connected by an EMA-licensed gas service worker. Licensing splits at roughly 30 mbar operating pressure, with different worker classes covering low-pressure domestic-style installations versus higher-pressure commercial setups.

Unlicensed gas work is a serious safety risk — leaks and faulty connections are a leading cause of fires and explosions — and it is also a regulatory offence. It is also the kind of defect an insurer will use to deny a claim after an incident if the work wasn’t done by a properly licensed worker.

WHEN
not independently confirmed — engage a licensed gas service worker early
COST
Not independently confirmed
indicative, checked 2026-09
WHO DOES IT
A qualified contractor
LEGAL BASIS
Gas Act and its subsidiary regulations, administered by EMA.
Find a licensed gas service worker

We don’t yet have a vetted directory for Singapore — ask your landlord or trade association for a recommendation.

Who this is for

Any kitchen with gas cooking equipment or gas-fired water heating.

Applies to any gas installation; the specific worker class required depends on the operating pressure of your installation — confirm with your contractor which class covers your setup.

What you’ll hold

  • Gas installation certificate / sign-off from the licensed gas service worker

Watch out for

Sources

See also

This is item 15 of 36 in the free Singapore Launch Checklist. See the whole list →